Measurement Computing DASYLab - Manual (Page 56)

B-2 Configuring DASYLab for Daq Devices 989593 DASYLab – Standard Driver
After DASYLab has been installed you will install the IOtech Drivers from your IOtech Data
Acquisition CD, as described in the upcoming section.
Make sure a check mark appears next to your selection(s). Choices that are merely
highlighted and not checked will not be installed.
A final screen displays the selected options about to be installed. Be sure the report matches your intended
choices. Step back to modify settings if needed.
Note: After software installation is complete, you may be required to restart Windows. After restart,
continue with the following section, Install Low-Level Hardware Driver.
Install Low-Level Hardware Driver
If the hardware drivers for your device are not installed, or if you have received a new IOtech Data
Acquisition CD, follow these steps.
Both the low-level drivers, installed from the Data Acquisition CD, and the DASYLab
drivers, installed from the DASYLab CD, are required for DASYLab operation.
Note: The installation will automatically perform version verification to ensure that only newer support is
installed.
1. Launch the IOtech Data Acquisition Software CD. Note that the CD should auto-start.
If the CD does not auto-start, run the CD start.exe from the Windows Desktop.
2. Select the hardware models that you will be using.
3. Select DASYLab Support.
4. Click the Start Install button.
5. When the DASYLab Hardware Driver Selection dialog appears select
Standard Driver [DaqBook/Board 100 & 2000 Series, DaqTemp, TempBook].
See the following figure.