Measurement Computing DASYLab - Manual (Page 35)

DASYLab – Enhanced Driver
977491 IOtech 640 & 650 Series Devices 4-7
Note: If you did not receive the version listed on your purchase order, contact IOtech’s Technical Support
Department at [email protected].
7. Click to close the “Information about DASYLab” window.
This completes the software installation process. At this point you can access DASYLab Help via the Help pull-down
menu; or access device-specific help as discussed below.
To access IOtech Device-specific help:
1. Open the Measurement pull-down menu in DASYLab [preceding figure]. (See note)
2. Select Hardware Setup.
3. Select Driver.
Note: In earlier versions of DASYLab the Measurement pull-down menu is labeled Experiment and the
Hardware Setup sub-menu item is labeled Experiment Setup.