Measurement Computing DASYLab - Manual (Page 3)

© by IOtech 989791
About this Document
This document serves as a supplement to data acquisition device user’s manuals and to DASYLab documentation which is
included on the DASYLab installation CD. It is intended to help you with your initial setup of IOtech data acquisition
hardware in DASYLab.
The document steps through software installation configuration issues and provides screen shots so you can more
easily setup and use your equipment.
Since the document covers several different types of hardware look over the table of contents and refer only to the
section(s) that apply to your applications.
Contents
1 - Configuring DASYLab for Daq, WaveBook, Personal Daq/3000 Series Devices
– Enhanced Driver ……
1-1 *
2 - Configuring DASYLab for Personal Daq/54, /55, and /56 …… 2-1
3- Configuring DASYLab for PointScan …… 3-1
4 - Configuring DASYLab for IOtech 640 & IOtech 650 Series
– Enhanced Driver
…… 4-1
Appendices
Appendix A - Configuring DASYLab for WaveBook - Standard Driver ** …… A-1
Appendix B - Configuring DASYLab for Daq Devices - Standard Driver ** …… B-1
Appendix C– Cal Notes for DBK19, DBK52, and TempBook/66 …… C-1
* Chapter 1 of this document provides: (1) an introduction to the enhanced driver, (2) driver installation instructions, and
(3) explains how to access the Help file. The Help file provides detailed configuration instructions for Daq,WaveBook,
Personal Daq/3000 Series, and IOtech 640 and 650 Series devices; and should be referred to after the enhanced driver
is installed.
** The Standard Driver does not support Windows Vista.
** The Standard Driver does not support DASYLab 10 (or higher).
Reference Note:
The DASYLab installation CD includes a “Getting Started with DASYLab” document in PDF format.
We highly recommend that you review that document, especially if you are new to DASYLab or have
been away from the application for an extended time.