Measurement Computing DASYLab - Manual (Page 58)

B-4 Configuring DASYLab for Daq Devices 989593 DASYLab – Standard Driver
Select the Driver
1. Start DASYLab and go to Experiment ⇒ Select Driver (see following figure).
Experiment / Select Driver Window
2. When the driver selection menu is presented, select the desired IOtech hardware products from the
list. You may be prompted to restart DASYLab for the changes to take effect. If so, exit and restart
DASYLab before continuing.
3. Click Help ⇒ About DASYLab. The Information about screen will appear (following figure).
Information Screen
If you did not receive the version listed on your
purchase order, contact IOtech’s Technical
Support Department at
[email protected]
4. In the DLL Driver frame, make sure you have version IOT5.06 or higher.
5. In the Virtual Driver frame, make sure you have DaqX 2.09 or higher.
6. Use the Additional Options tab to confirm that the options you purchased have been properly
installed.
7. Click OK to close the Additional Options window.