Measurement Computing DASYLab - Manual (Page 24)

3-6 Configuring DASYLab for PointScan 876994 DASYLab – Standard Driver
DASYLab
Install DASYLab
DASYLab software versions that precede 6.0 do not support PointScan products.
If your DASYLab version precedes 6.0, please contact [email protected] for upgrade
information.
For DASYLab to properly install, the host computer must be using Internet Explorer
version 5.0 or higher.
Install DASYLab as follows:
1. Launch the DASYLab installation from the DASYLab CD.
Note: The CD should auto-start. If the CD does not auto-start, run the CD start.exe from the
Windows Desktop.
2. Select “Install DASYLab.”
3. When prompted for your name, company and serial number, enter the requested data.
Obtain the serial number from the CD jacket.
Keep the serial number in a safe place. You may need to reference it for future
installations and upgrades.
4. When prompted for the installation directory and program folder, you can use the default selection,
or choose another. We recommend using the default.
5. When prompted for Setup Type, choose from the available options. We recommend that you select
Typical.
6. Select the applicable hardware drivers when prompted. See the following note and figure.
There are no PointScan related drivers to select. The drivers that are selected in
step 6 are for components that are in addition to PointScan.
Be sure to place a check mark next to each of your selections. Choices that are not
checked will not be installed, even if they are highlighted.
Selecting Drivers in DASYLab Setup
A screen displays the selected options. If needed, use the <Back> button and make the
appropriate changes.