Measurement Computing DASYLab - Manual (Page 59)

DASYLab – Standard Driver 989593 Configuring DASYLab for Daq Devices B-5
Configure the Hardware
Before configuring DASYLab's hardware settings, make sure the hardware is setup properly. Checking for
valid readings with DaqView first is recommended. If the hardware has jumpers, make sure they are in the
desired positions.
Use the following steps to setup DASYLab to work properly with your hardware.
1. Launch the DASYLab application.
2. Open the Hardware Configuration dialog box in either of two ways:
(a) click on the circuit board in the horizontal toolbar, or
(b) click on Experiment in the menu bar and then click on Hardware Setup.
Toolbar showing Experiment Menu and Hardware Setup Button
A dialog box similar to the following will appear:
Hardware Configuration Dialog Box
The Hardware Configuration Devices region (see above figure) shows the hardware configuration as
defined in the current configuration file.
Notes:
• Trigger Settings are configured from the Hardware Configuration dialog box.
• The Configuration file stores all current hardware settings (see following reference note).