Legrand OR-205KAN9GB-MM User Manual

Page 30

Page 23

Carefully insert the bare fiber into the stem of the connector until you feel the end of the fiber touch the
fiber stub inside the connector. Gently rotating the fiber between your thumb and forefinger may ease
insertion. DO NOT rotate or remove the fiber once fully inserted into the connector. When fully inserted,
the pen mark on the buffer should be near the edge of the connector stem. Clamp the fiber into the
installation tool clamp as shown in Fig. 1. In order to ensure that the fiber end face being installed
maintains contact with the fiber end face inside the connector during subsequent handling, there MUST
BE a bow of approximately 15 mm–20 mm (0.6 in.–0.75 in.) as illustrated.

Installation on 900 µm tight buffered fiber or loose tube with breakout kit

15 mm–20 mm
(0.6 in.–0.75 in.)

Figure 1

Pen mark

Installation Tool

Fiber Clamp

OptiMo Connector Installation Instructions

This manual is related to the following products:

OR-205KAN9GA-MM OR-205KAN9GB-SM OR-205KAN9GA-SM OR-60300128 OR-60300126 OR-205KAN9FB-MM OR-205KAN9FA-MM OR-205KAN9FB-SM OR-205KAN9FA-SM OR-205KAN9EB-MM OR-205KAN9EA-MM OR-205KAN9EBSM OR-205KAN9EA-SM OR-205KAS9GB-50T OR-205KAS9GA-50T OR-205KAS9GB-62 OR-205KAS9GA-62 OR-205KAS9GB-09 OR-205KAS9GA-09 OR-205KAS9FB-50T OR-205KAS9FA-50T OR-205KAS9FB-62 OR-205KAS9FA-62 OR-205KAS9FB-09 OR-205KAS9FA-09 OR-205KAS9EB-50T OR-205KAS9EA-50T OR-205KAS9EB-62 OR-205KAS9EA-62 OR-205KAS9EB-09 OR-205KAS9EA-09