Legrand 291-H/BTC - Manual

Suitable for use in air handling spaces in accordance with Sec. 300-22 (C) of the National Electrical Code.
Step 1. Layout and locate position of hole(s). Step 2. Core drill hole.
CAUTION: Holes shall be spaced a minimum of 2' [610mm]
on center and not more than one hole per each
65 sq. ft. [6 sq. m] of floor area in each span.
NOTE: Be certain to drill hole at least 4" [102mm] from any wall
or pillar to leave enough room for poke-thru cover assembly.
Step 3. Carpet Option.
Remove section from carpet using disposable plate or template.
RC9FFS, RC9AFFTC, 291-H/BTC,
292-H/BTC, RC91GHBTC, RC92GHBTC,
and RC9CFFTC
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: 1 001 997 R2 – Updated July 2005
Wiremold Electrical Systems conform to and should be installed
and properly grounded in compliance with requirements of the
current National Electrical Code, Canadian Electrical Code or
codes administered by local authorities.
All electrical products may represent possible shock or fire
hazard if improperly installed or used. Wiremold electrical
products are UL listed. Made for interior use only and should be
installed in conformance with current local and/or the National
Electrical Code.
24" [610mm] Min
Center – Center
3" Diameter Core Drill
3 1/16" [78mm] Actual Diameter
RC91GHBTC, RC92GHBTC,
291-H/BTC, 292-H/BTC
Style Service Heads
(Carpet Only)
RC9AFFTC, RC9CFFTC
6 1/2" [165mm] Diameter
Cutout (Carpet Only)
Make Concentric with Intended Core Hole
IMPORTANT: Please read all instructions
before beginning.