Legrand 825 Series Floor Box - Manual

Products Covered: 825CP
Activation:
1. Remove mudcap and any debris.
2. Thread 825CP carpet ring assembly
into adjusting ring until snug with
carpet using box wrench (see Figure 1).
Products Covered: 825R15 and 825R2
Activation:
1. Remove mudcap and any debris.
2. Route cables through box body.
3. Wire device in accordance with
National Electrical Code or any local
code that applies. Make sure the
ground lead is
connected to the ground screw.
4. Place receptacle on adjusting ring
and install gasket.
5. Thread 825CK on adjusting ring
(see Figure 2).
825 Series Floor Box
Component and Accessories
INSTALLATION INSTRUCTIONS
Installation Instruction No.: 1 001 438 R1 – Updated September 2006
Figure 1
Box Wrench
825R15 (Shown)
825CK
Gasket
Ground Wire
825CP
Figure 2
Wiremold / Legrand electrical systems conform to and should be
properly grounded in compliance with requirements of the current National
Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Wiremold / Legrand electrical
products may bear the mark as UL Listed and/or Classified and should
be installed in conformance with current local and/or the National
Electrical Code.
IMPORTANT: Please read all instructions
before beginning.