Legrand OR-205KAN9GB-MM User Manual

Page 21

If unfamiliar with cleaving, it is advised to practice using a spare piece of fiber.

Make sure the fiber optic stripper tool you are using is in proper operating condition before attempting this step.
Use of a tool that is not in proper operating condition could cause the fiber to break.

Page 14

Strip the 900 µm tube as shown below such that the distance from the end of the tube to the end of the
fiber is approximately 40 mm. Tube end should be clean and square.

Fiber waste

Fig. 1

Fig. 2

Fig. 3

Step 1. (Fig. 1) Insert fiber into

Step 2. (Fig. 2) Close the tool

Step 3. (Fig. 3) Draw the tool along the fiber

900 µm "V" opening of the tool.

squarely around the fiber.

using thumb pressure while keeping the tool
perpendicular to the fiber.

Installation: stripping 900 µm loose tube fiber with breakout kit

(if using tight buffered, go to step 5)

OR-71601671

900 µm "V" opening

250 µm "V" opening

This manual is related to the following products:

OR-205KAN9GA-MM OR-205KAN9GB-SM OR-205KAN9GA-SM OR-60300128 OR-60300126 OR-205KAN9FB-MM OR-205KAN9FA-MM OR-205KAN9FB-SM OR-205KAN9FA-SM OR-205KAN9EB-MM OR-205KAN9EA-MM OR-205KAN9EBSM OR-205KAN9EA-SM OR-205KAS9GB-50T OR-205KAS9GA-50T OR-205KAS9GB-62 OR-205KAS9GA-62 OR-205KAS9GB-09 OR-205KAS9GA-09 OR-205KAS9FB-50T OR-205KAS9FA-50T OR-205KAS9FB-62 OR-205KAS9FA-62 OR-205KAS9FB-09 OR-205KAS9FA-09 OR-205KAS9EB-50T OR-205KAS9EA-50T OR-205KAS9EB-62 OR-205KAS9EA-62 OR-205KAS9EB-09 OR-205KAS9EA-09