Legrand OR-205KAN9GB-MM User Manual

Page 13

Page 6

Strip approximately 40 mm of the 900 µm buffered fiber as shown below. Be sure to strip fiber in small
(5 mm) sections to avoid breaking it. Buffer end should be clean and square.

Fiber waste

Fig. 1

Fig. 2

Fig. 3

Step 1. (Fig. 1) Insert fiber into

Step 2. (Fig. 2) Close the tool

Step 3. (Fig. 3) Draw the tool along the fiber

250 µm "V" opening of the tool.

squarely around the fiber.

using thumb pressure while keeping the tool
perpendicular to the fiber.

900 µm "V" opening

250 µm "V" opening

Installation: stripping 900 µm tight buffered fiber

(if using loose tube with breakout kit, skip to step 11)

If unfamiliar with stripping optical fiber, it is advised to practice using a spare piece of fiber.

Make sure the fiber optic stripper tool you are using is in proper operating condition before attempting this step.
Use of a tool that is not in proper operating condition could cause the fiber to break.

OR-71601671

This manual is related to the following products:

OR-205KAN9GA-MM OR-205KAN9GB-SM OR-205KAN9GA-SM OR-60300128 OR-60300126 OR-205KAN9FB-MM OR-205KAN9FA-MM OR-205KAN9FB-SM OR-205KAN9FA-SM OR-205KAN9EB-MM OR-205KAN9EA-MM OR-205KAN9EBSM OR-205KAN9EA-SM OR-205KAS9GB-50T OR-205KAS9GA-50T OR-205KAS9GB-62 OR-205KAS9GA-62 OR-205KAS9GB-09 OR-205KAS9GA-09 OR-205KAS9FB-50T OR-205KAS9FA-50T OR-205KAS9FB-62 OR-205KAS9FA-62 OR-205KAS9FB-09 OR-205KAS9FA-09 OR-205KAS9EB-50T OR-205KAS9EA-50T OR-205KAS9EB-62 OR-205KAS9EA-62 OR-205KAS9EB-09 OR-205KAS9EA-09