Gasboy SiteOmat Users Manual - Manual (Page 91)

To update a price, proceed as follows:
1. Select a product from the list
2. Enter the new price in the Price Update field
3. To update a price immediately, check the Update price now checkbox before approving. To
schedule a future update select the Effective date by using the date and time dialog box
4. Click Modify. The following confirmation message appears: “Are you sure you want to
change price for product X”?
5. Click OK
The user is notified via an alarm in cases where the update process has failed for any of the
stations.
6-2.1. Edit Product
To edit/add a product, perform the following steps:
1. Click on the Edit Products button. The Setup Fuel Products dialog box (see Figure 6-2)
appears
2. To edit an existing product click on the relevant row in the upper grid. To add a new
product, enter its identification Name and Code. The nominal Density of the fuel needs to
be defined. Enter zero (0) if not applicable
3. Select the Product color to represent the product in graphic reports. Click on the color and a
pop up color palette appears
4. Set the Reorder level alarm. The alarm is triggered as soon as the total volume level in all
tanks containing this product falls lower than the set value. See Section 6.8 in the SiteOmat
Setup Manual, MDE-4817 for more information on alarms setup
5. Set the Dead band for this alarm. Dead band is a technique used to eliminate noise when
generating alarms. Each alarm defined by an analog threshold value, has also a dead band
defined in percentage. The alarm is not activated or stopped at the nominal value, but at the
addition of the +/- percentage value of the dead band. For example, considering an alarm set
value of 100 with a dead band of 5%: the alarm is triggered (delayed) when the value is
higher than 105, and stops similarly when the value is lower than 95
6. Click OK or Modify in the Products dialog box to save all the settings
7. Click Close to exit the dialog box
Users may as well delete a product from the list. First, select it by clicking on its row. Once its
parameters are displayed, click Delete.
If a product is in use, it cannot be deleted. In order to delete a product, it must be removed from an
association with the tank, and the tank’s association to the pumps must also be removed.
SiteOmat User’s Manual– MDE 4818 87