D-Link DES-3326 - Manual (Page 51)

DES-3326 Layer 3 Fast Ethernet Switch User’s Guide
Figure 5-13. TCP Packet Header
When packets have been successfully received, TCP sends an acknowledgement. This is simply a
packet that has the acknowledgement number field filled in.
An acknowledgement number of 1000 indicates that all of the data up to octet 1000 has been received.
If the transmitting TCP does not receive an acknowledgement in a reasonable amount of time, the data
is resent.
The window field controls the amount of data being sent at any one time. It would require too much
time and overhead to acknowledge each packet received. Each end of the TCP connection declares how
much data it is able to receive at any one time by writing this number of octets in the window field.
The transmitting TCP decrements the number in the window field and when it reaches zero, the
transmitting TCP stops sending data. When the receiving TCP can accept more data, it increases the
number in the window field. In practice, a single packet can acknowledge the receipt of data and give
permission for more data to be sent.
IP
TCP sends its packets to IP with the source and destination IP addresses. IP is only concerned with
these IP addresses. It is not concerned with the contents of the packet or the TCP header.
IP finds a route for the packet to get to the other end of the TCP connection. IP adds its own header to
the packet to accomplish this.
The IP header contains the source and destination addresses, the protocol number, and another
checksum.
The protocol number tells the receiving IP which protocol to give the packet to. Although most IP traffic
uses TCP, other protocols can be used (such as UDP).
The checksum is used by the receiving IP in the same way as the TCP checksum.
51