D-Link DES-3326 - Manual (Page 125)

DES-3326 Layer 3 Fast Ethernet Switch User’s Guide
Figure 6-43. Setup RIP screen
The following fields can be set:
Parameter Description
Interface
name:[System ] The name of the IP interface on
which RIP is to be setup. This
interface must be previously
configured on the switch.
TX Mode<Disabled> Toggle among Disabled, V1 Only, V1
Compatible, and V2 Only. This entry
specifies which version of the RIP
protocol will be used to transmit RIP
packets. Disabled prevents the
transmission of RIP packets.
RX
Mode<Disabled> Toggle among Disabled, V1 Only, V2
Only, and V1 and V2. This entry
specifies which version of the RIP
protocol will be used to interpret
received RIP packets. Disabled
prevents the reception of RIP
packets.
Authentication: Toggle between Enabled and
Disabled. When authentication is
enabled, a password is used to
authenticate communication
between routers on the network.
Authentication is only supported
when RIP is in V1 Compatible or V2
only mode.
Password: A password to be used to
authenticate communication
between routers on the network.
125