D-Link DES-3326 - Manual (Page 102)

DES-3326 Layer 3 Fast Ethernet Switch User’s Guide
Parameter Description
View Ports:
<1 to 12 >
Toggle the View Ports field, using the space bar, to
view the configuration of either ports 1 through 12
or ports 13 through 24.
State:<Enabled> Toggle the State field to either Enable or Disable a
given port.
Speed/Duplex:
<Auto>
Toggle the Speed/Duplex field to either select the
speed and duplex/half-duplex state of the port.
Auto – auto-negotiation between 10 and 100 Mbps
devices, full- or half-duplex. The Auto setting allows
the port to automatically determine the fastest
settings the device the port is connected to can
handle, and then to use those settings. The other
options are 100M/Full, 100M/Half, 10M/Full, and
10M/Half. There is no automatic adjustment of port
settings with any option other than Auto.
Flow Control:
Auto
Displays the flow control scheme used for the
various port configurations. Ports configured for
full-duplex use 802.3x flow control, half-duplex
ports use backpressure flow control, and Auto ports
use an automatic selection of the two.
Lock:<Disabled> Allows the selected port (or port’s) dynamic MAC
address learning to be locked such that new source
MAC addresses cannot be entered into the MAC
address table for the locked port. It can be changed
by toggling between Disabled and Enabled.
Serial Port Settings
The Serial Port Settings screen allows the configuration of the switch’s serial port and out-of-band
TCP/IP communications using SLIP.
Highlight Serial Port Settings and press Enter.
102