D-Link DES-3326 - Manual (Page 223)

DES-3326 Layer 3 Fast Ethernet Switch User’s Guide
Figure 7-37. Route Redistribution Settings window
The following fields can be set or are displayed:
Parameter Description
Source Protocol Allows the selection of the protocol of
the source device. Available choices
are RIP, OSPF, or Static.
Dest. Protocol Allows the selection of the protocol of
the destination device. Available
choices are RIP and OSPF.
Metric Type Allows the selection of one of two
methods for calculating the metric
value. Type-1 calculates the metric
(for RIP to OSPF) by adding the
destination’s interface cost to the
metric entered in the Metric field.
Type-2 uses the metric entered in the
Metric field without change. This
field applies only when the
destination field is OSPF.
Metric Allows the entry of an OSPF interface
cost. This is analogous to a Hop
Count in the RIP routing protocol.
Multicasting
Layer 2 Multicast Setup
The following menus are used to setup the switch’s Layer 2 multicasting features.
IGMP Snooping Settings
To configure IGMP Snooping:
223