D-Link DES-3326 - Manual (Page 202)

DES-3326 Layer 3 Fast Ethernet Switch User’s Guide
The following fields can be set:
Parameter Description
State <Enabled> Toggle the State field to either enable or disable a given
port.
Speed/Duplex
<Auto> Toggle the Speed/Duplex field to either select the speed and
duplex/half-duplex state of the port. Auto – auto-
negotiation between 10 and 100 Mbps devices, full- or half-
duplex. The Auto setting allows the port to automatically
determine the fastest settings the device the port is
connected to can handle, and then to use those settings.
The other options are 100M/Full, 100M/Half, 10M/Full, and
10M/Half. There is no automatic adjustment of port settings
with any option other than Auto.
Flow Control: Auto Displays the flow control scheme used for the various port
configurations. Ports configured for full-duplex use 802.3x
flow control, half-duplex ports use backpressure flow
control, and Auto ports use an automatic selection of the
two.
Lock <Disabled> Allows the selected port (or port’s) dynamic MAC address
learning to be locked such that new source MAC addresses
cannot be entered into the MAC address table for the locked
port. It can be changed by toggling between Disabled and
Enabled.
Serial Port Settings
The Serial Port Settings window allows the configuration of the switch’s serial port and out-of-band
TCP/IP communications using SLIP.
Click on the Serial Port Settings link on the Management menu.
202