D-Link DES-3326 - Manual (Page 245)

DES-3326 Layer 3 Fast Ethernet Switch User’s Guide
Figure 7-66. BOOTP/DHCP Relay window
The following fields can be set:
Parameter Description
BOOTP/DHCP
Relay Status
<Disabled>
This field can be toggled between Enabled and Disabled
using the pull-down menu. It is used to enable or disable
the BOOTP/DHCP Relay service on the switch. The default
is Disabled
BOOTP HOPS
Count Limit [4 ] This field allows an entry between 1 and 16 to define the
maximum number of router hops BOOTP messages can be
forwarded across. The default hop count is 4.
BOOTP/DHCP
Relay Time
Threshold [0 ]
Allows an entry between 0 and 65535 seconds, and defines
the maximum time limit for routing a BOOTP/DHCP packet.
If a value of 0 is entered, the switch will not process the
value in the seconds field of the BOOTP or DHCP packet. If
a non-zero value is entered, the switch will use that value,
along with the hop count to determine whether to forward a
given BOOTP or DHCP packet.
To configure the BOOTP/DHCP Relay interface:
Click the BOOTP/DHCP Relay link and then the Static Setup link:
Figure 7-67. BOOTP/DHCP Relay Interface Setup window
The following fields can be set:
Parameter Description
Interface Name The interface name of the IP interface
on which the BOOTP or DHCP
245