Daktronics Pro Series Operations and Maintenance Manual - Manual (Page 91)

E-STOP DISPLAY
When no E-Stop is used, the VAC will operate
normally. A display appears (Figure 11.2) when
one of the E-Stops is pulled. T he E-STOPS
button starts flashing and an alert box with
the name of the E-Stop is displayed for two
seconds.
Touch the E-STOPS button and the E-Stop Alert
panel will display ( Figure 11. 3). Note: In Manual or
Setup, the interface will be frozen while the E-Stop
Alert panel is displayed.
If another E-Stop is engaged while the panel is
open, then its name will appear at the top of the
list ( Figure 11.4 ).
Figure 11.2: An E-Stop is pulled out.
Figure 11. 3 : E-Stop Alert panel with active
E-Stop displayed
Figure 11.4: E-Stop Alert panel with name of other E-Stop
.
84