Daktronics Pro Series Operations and Maintenance Manual User Manual

Page 51

Modify Action

From the Modify Action screen (Figure 7.26), touch

MODIFY to edit the values in the cue. Figure 7.28

shows the Modify Action screen.
Touch the value that is to be changed and the

appropriate screen will display, allowing the

desired changes.
If an action contains a motor used later in the cue,

its target or time/speed can not be modified. The

later cue depends on the earlier action’s completion

and the only way to assure this is to eliminate the

ability to modify it.

Note: If the motor/group changes, then the target and

time/speed must change. If the target changes, then the

time/speed must change.

MORE CUES

Figure 7.29 shows the More Cues screen. Touch

YES to add more cue actions, or touch NO to stop

entering cues.
When YES is selected, enter the motor/group for the

next cue action. The number and title are the same

throughout a cue, so if more actions are added, the first

two values are not entered again. Enter the information

for the remaining cue actions.

Figure 7.30 shows the Loaded show screen. Four

options are available: DELETE, MODIFY, ADD or RUN.

Figure 7.29: More Cues screen

Figure 7.28: Modify Action screen

Figure 7.30: Loaded show displayed