Daktronics Pro Series Operations and Maintenance Manual - Manual (Page 64)

Figure 8.11: Keypad showing boundaries
Figure 8.10: Up arrow depressed
Figure 8.2: UPR button shows the upper limit is 100;
LWR button shows the lower limit is 3.
PRESETS
Up/Down
Touch and hold either button to move the motor in
that direction. As the motor moves, its target value
moves as well.
When either of the arrows are pressed, they divide
into three areas (Figure 8.10). Push the minus (-) to
decrease the speed, or plus (+) to increase it while
the motor is moving.
The motor will stop moving when your finger leaves
the button or the motor has reached its limit.
Keypad
To enter the target value manually, touch the
KEYPAD button and a keypad will display (Figure
8.11). The keypad displays the boundaries for the
target value.
Touch CHANGE to confirm the new target value or
CANCEL to return to the main Preset screen without
changing the target.
UPR / LWR
Touch UPR or LWR to use the value of the upper
limit or lower limit as displayed on the button
(Figure 8.12).
WARNING If any problems arise during
any hoist motions, depress the
Emergency Stop button located
below the monitor immediately and
all hoist movements will stop.
57