Daktronics Pro Series Operations and Maintenance Manual - Manual (Page 37)

CREATE GROUP
The Create function has two motor lists, the Motors
list and the Group Motors list (Figure 6.2). Move
through either list by using the scroll button, PgUp or
PgDn.
To add a motor to the group, touch its name in
the available motor list. The motor is immediately
removed from the available list and is displayed
in the group motor list.
To remove a motor from the group, touch its name
in the group motor list. The motor is immediately
removed from the group motor list and is
displayed back in the available list.
On the left is a list of the all available motors (in
alpha-betical order). A motor that is disabled or
part of another group will not appear here. On
the right is a list of all motors selected to be
grouped, which is empty at this point.
Touch CANCEL to go back to the main screen
without creating the group.
When all of the desired motors are shown in
the group motor list, touch DONE to name the
new group.
Figure 6.3: Motors added to group
Figure 6.2: Create function.
30