Daktronics Pro Series Operations and Maintenance Manual - Manual (Page 40)

GROUPING
Figure 6.8: Trim motor
Figure 6.9: Trim controls activated
Trim motor
To change the position of an individual batten
within a group, use the Trim function.
Select a motor to trim from the list of grouped
motors on the left (Figure 6.8).
The trimming controls activate after a motor has
been selected (Figure 6.9).
The up and down arrow buttons will move the
batten at minimum speed. Touch and hold an
arrow button to begin moving the selected motor.
The motor will stop moving when the button
is released.
Touch EXIT to return to the Edit menu.
Joystick control
The joystick provides faster trimming speed.
To control the motor with the left joystick, touch
JOYSTICK under the arrow buttons (Figure 6.9).
The button will change to read FINISHED and all
other screen controls are deactivated. The left joystick
is now activated to move the selected motor. The
motor speed increases as the joystick moves farther
from center. Push the joystick forward for the up
direction and backwards for the down direction.
When the batten is in the correct position, touch
FINISHED to activate the rest of the controls and
deactivate the joystick.
33