Daktronics Pro Series Operations and Maintenance Manual - Manual (Page 79)

Set Upper / Lower Limits
Touch the desired SET/CLEAR limit buttons.
A keypad displays where you can enter a new value
for the limit manually (Figure 9.23).
Enter the height for the limit using the keypad
(Figure 9.24). Then touch KEYPAD to confirm the
new value. If the number is out of range, the keypad
display acceptable values and you must touch
Cancel must be touched to start over.
Touch Current to use the batten’s current position for
the value of the limit.
After entering a new limit or using current batten
position, touch Continue to return to the main Setup
screen or touch the button above the keypad to set
the opposite limit.
Clear Upper / Lower Limit
Touch the desired CLEAR button to clear a limit
(Figure 9.23). Until a new value is set, the limit
will be the same value as the maximum
operational limits (set by the factory).
The clear button touched will change to read
CONFIRM. Touch this button to confirm clearing
the limit.
Figure 9.23: Set/Clear Limits panel
Figure 9.24: Set Upper Limits panel
72