Daktronics Pro Series Operations and Maintenance Manual User Manual

Page 63

Figure 8.6: Motor 0 is omitted.

Figure 8.7: Change position arrows

Figure 8.8: After position is changed

Keypad

UPR (upper limit)

Joystick

Down

LWR (lower limit)

Figure 8.9: Target controls

Omit Motor

In some presets, not every motor is used. To

remove a motor from the list, select it and touch

OMIT MOTOR.
The motor name will deactivate to show that it

will not move in the preset (Figure 8.6).

Move in List

To change the sequence in which the motors move,

select the motor and touch the MOVE IN LIST button.
Choose a new list position for the motor by touching

one of the grey arrows that appear (Figure 8.7).

MOVE IN LIST changes to read ACCEPT.
Touch ACCEPT to confirm the new list position. The

order list displays the updated order (Figure 8.8).

All

To add all omitted motors back into the order list,

touch ALL. When omitted motors are added, check

to make sure the target values are correct.

Target controls

Select a motor from the list by touching its name.

Now the top of the Target controls will display

the name of the selected motor (Figure 8.9).