Daktronics Pro Series Operations and Maintenance Manual - Manual (Page 70)

SETUP
09 SETUP
The Setup module is very similar to the
Manual module but with two differences. The Setup
module (Figure 9.1)works with limits (instead of
targets) and has the controls to calibrate the i-Batten
safety feature.
The Setup module has two controllers, each of which
controls a motor, group or curtain. After selecting a
motor, its name, speed, position, limits
or icons may be changed.
If the safety feature is disabled for a motor or group,
the controller will display a red slash over the i-Batten
logo (Figure 9.2).
If a weight change for the batten is detected, the
motor will stop moving until the batten weight returns
to normal.
Figure 9.2: i-Batten status
Enabled Disabled
Figure 9.1: Setup module
63