BECKHOFF EP2xxx - Manual (Page 96)

Mounting and cabling
Fig. 89: Digital outputs, M8 and M12
The outputs are short­circuit safe and protected against inverse connection.
The outputs indicate their status through light emitting diodes.
3.6.2 Digital outputs M12 for EP2028­0032
The digital outputs / actuators are connected via M12 sockets.
Pin 2 and 4 of channel 0 and 1, channel 2 and 3, channel 4 and 5 as well as channel 6 and 7 are connected.
Therefore also actuators witch needs 2 outputs can be connected via one M12 cable.
Fig. 90: Digital outputs M12 for EP2028­0032
The state of the signals is indicated by light emitting diodes.
3.6.3 Digital outputs Sub­D 25, 16 channels
The EP2816 digital output module transmits the binary control signals from the automation unit on to the
actuators at the process level.
The 16 outputs deliver load currents of up to 0.5 A, although the total current from all the outputs must not
exceed 4 A.
The signal connection is made through a 25­pin sub­D socket.
The outputs are short­circuit proof and protected against inverse connection.
EP2xxx 96 Version 2.1.0