BECKHOFF EP2xxx - Manual (Page 19)

Product overview
2.5 EP2028­0032
2.5.1 EP2028­0032 ­ Introduction
Fig. 8: EP2028­0032
8 digital outputs 24 V
DC
, I
max
2,8A (Σ 16 A)
The EP2028­0032 EtherCAT Box with digital outputs connects the binary control signals from the controller
on to the actuators at the process level.
The eight outputs handle load currents of up to 2.8 A each, although the total current is limited to 16 A.
Thence this modules are especially suitable for applications, at which a high utilization factor with high output
current is necessary.
The signal state is indicated by means of light emitting diodes. The signals are connected via M12 type
connectors. The outputs are short­circuit­proof and protected against inverse connection.
Pin 2 and 4 of channel 0 and 1, channel 2 and 3, channel 4 and 5 as well as channel 6 and 7 are connected.
Therefore also actuators witch needs 2 outputs can be connected via one M12 cable.
Quick links
Installation
Actuator connection [ } 96]
UL requirements for UL approved modules
ATEX ‐ special conditions [ } 92] for ATEX approved modules
EP2xxx 19 Version 2.1.0