Becker revo.2 - Manual (Page 22)

22
>>> GENERAL OPERATION
> D
> GB
> F
> I
> PL
Cable for vehicle integration
(depending on model, optional)
With a 4-pin 2.5mm jack cable you can
integrate your Navigation device
seamlessly into your vehicle.
• connect your Navigation device to the
phone mute function of your audio
system. If the cable is connected
correctly, your audio system will mute
the car radio during navigation
announcements.
• connect your Navigation device to your
audio system for output of the audio
signal.
> Insert the cable into the 2.5mm socket
provided on the back of the basic unit,
also see Seite 17.
Cable for rear view camera
(depending on the model,
optional)
You can connect your rear view camera
to your navigation device using a 4-pin
2.5mm AV cable. Insert the cable into the
socket provided on the back of the basic
unit, also see Seite 17.
You can make the necessary settings in
the chapter "Reversing camera" on page
127.
GND
Telephone Mute:
Audio-R
Audio-L
Note:
Once the cable is connected, the
loudspeaker of the basic device is
switched off. The Tel-Mute function
cannot be used with the cable supplied.
A cable must be individually
manufactured for this.
GND
Video
Audio-R
Audio-L