Becker revo.2 - Manual (Page 13)

13
THE NAVIGATION DEVICE >>>
> D
> GB
> F
> I
> PL
Battery
When depleted, the integrated
rechargeable battery can be recharged
by connecting the Navigation device to
the power supply.
For this purpose, connect the unit via a
car power adapter to a 12/24 V socket in
a vehicle or via the optional mains power
supply unit to the 230 V mains.
USB connection cable
With the USB connection cable provided,
it is possible to connect the Navigation
device to a standard PC with a USB inter-
face. The integrated flash memory of the
navigation device and a micro SD card
that may eventually be inserted can then
be addressed by the PC like a removable
storage device.
Unit bracket
The Navigation device can be mounted in
the vehicle using the unit bracket.
Accessories
Mains power supply unit
This power supply allows connection of
the Navigation device to a mains outlet.
The power supply must satisfy the
following requirements:
• Alternating current 100-240 volts
0.3 amps
50-60 Hertz
Cable for vehicle integration
(for certain models only)
With a 4-pin 2.5mm jack cable you can
integrate your Navigation device
seamlessly into your vehicle. Details of
the connection can be found under
"Cable for vehicle integration (depending
on model, optional)" on page 22.
Note:
The function can be switched off on
vehicles with switched vehicle voltage
sockets. It does not work on vehicles
with 24V vehicle voltage.
On vehicles with an automatic start/
stop feature, your navigation device
might always be switched off when the
engine is stopped.
Note:
You can charge the Navigation device
via the car charger cable included in the
scope of delivery or via the optionally
available mains power supply unit.
When the Navigation device is
connected to a PC, it is supplied with
power via the PC and does not consume
battery power.
Note:
Switch the navigation device completely
off, see "Switching the Navigation device
on/off (model dependent)" on page 24,
before connecting the navigation device
to the computer.