Avery Dennison Monarch 9906 Operator Handbook - Manual (Page 84)

P r i n t i n g a T e s t L a b e l
Two different test labels can be printed:
 Printer Information (gives printer setting information)
 MPCL Label (gives printer setting information)
Printer Information MPCL Label
Contains system level generic
information about the printer, including
inch counts and printhead resolution. Contains the current MPCL settings from
the MPCL Online Configuration packet.
To print a test label, from the Main Menu select TLABEL, then follow these steps.
1. Press  or  to scroll through the three test label options.
PRINT BACK
TEST LABEL
Printer Info →
2. When you see the test label you need, press PRINT. Press BACK to return to the
previous menu without printing a test label.
O n - D e m a n d M o d e P r i n t i n g
When the printer is operating in on-demand mode, the next label prints when the previous
label is removed or when FEED is pressed. The display shows "Printing X of Y" until all
labels in the batch print.
If you are using the optional peel module:
 you must use on-demand printing.
 remove excess liner by pulling up across the saw-toothed tear edge.
 hold the leading edge of peeled labels when printing on stock longer than six inches.
 minimum feed length is 1.5 inches.
 you must use non-perforated supplies.
 maximum speed is 8.0 ips.
 we recommend using 0.5-inch gap supplies when backfeed is disabled.
9-2 Operator's Handbook