Avery Dennison Monarch 9906 Operator Handbook - Manual (Page 38)

Setting the Margin Position
This function adjusts where the format prints horizontally on the supply. The adjustments
are in dots (0.0049 inch), which is the smallest measurement the printer recognizes.
The width of the print area depends on your supply size. Maximum width is four inches.
When you move the image to the right or left on the supply, avoid moving the image too
close to either edge, because it may not print.
Print too far to the left Print too far to the right
 If the data is too close to the left side,
increase the number.
 If the data is too close to the right side,
decrease the number.
Note:
Changing this setting only effects
new formats sent to the printer.
To change the setting, from the Main Menu, select Setup, Supply, Positioning. Then,
follow these steps.
1. Press  or  until you see Margin Pos.
2. Press CHANGE to highlight the margin positioning options. The current setting is
shown.
3.
Press  or  to increment/decrement the margin position.
0
CHANGE CANCEL
POSITIONING
Margin Pos
[-99/99] 0
10 SET CANCEL
← Margin Pos →
POSITIONING
Note: Pressing the left function button changes the increment/decrement amount
(changes by 1, 10, or 100).
4. When you see the margin position you need, press SET to save the change. Press
CANCEL
to leave the margin position unchanged.
5. Press BACK until you return to the Home/Online screen.
POSITIONING
← Margin Pos →
0
CHANGE BACK
4-10 Operator's Handbook