Avery Dennison Monarch 9906 Operator Handbook - Manual (Page 78)

U s i n g R F I D S u p p l i e s
RFID supplies are available in a variety of sizes. Refer to the 9906 RFID Setup Guide &
Supply Chart
for more information.
Do not modify the Supply Position when using RFID supplies with greater than a
two-inch feed length.
Doing so may move the RFID tag out of the RF Field’s readable
and programmable range. If necessary, you can modify the Print Position; however,
make sure you do not move the tag out of the readable and programmable range.
U s i n g t h e R F I D S e t u p M e n u
Use the RFID Setup Menu to Read a tag, set the RF Power, and Clear Data.
Read Tag
Use this option to read the EPC data programmed into an RFID tag. You cannot read the
user memory data.
To read a tag, from the Main Menu, select Setup, then RFID. Then follow these steps.
1. Press  or  until you see
← Read Tag →
ENTER BACK
RFID
2. Lay the RFID tag you just programmed inside the supply path with the tag’s antenna
over the printer’s box antenna (the box antenna is located behind the platen roller).
3. Press ENTER.
8-2 Operator's Handbook