Avery Dennison Monarch 9906 Operator Handbook - Manual (Page 67)

S e t t i n g t h e E r r o r R e t r y M o d e
You can set how the printer operates after a supply error has been cleared. The printer
can either reprint the job or discard/cancel the job. If you enable error retry, the printer
reprints the job that was in process when the error occurred. If you disable error retry, the
printer discards the job that was in process.
To change the setting, from the Main Menu, select Setup, then Defaults. Then, follow
these steps.
1. Press  or  until you see Error Retry.
2. Press CHANGE to highlight the error retry options. The current setting is shown.
3. Press  or  to scroll through the error retry options.
4. When you see the error retry mode you need, press SET to save the change. Press
CANCEL
to leave the error retry mode unchanged.
 Error Retry 
Enable
CHANGE BACK
DEFAULTS
Error Retry
 Enable 
SET CANCEL
DEFAULTS
 Error Retry 
Enable
CHANGE BACK
DEFAULTS
5. Press BACK until you return to the Home/Online screen.
Setting Defaults 6-15