Avery Dennison Monarch 9906 Operator Handbook - Manual (Page 18)

Loading Labels for Optional Peel Mode
Peel mode is optional and must be purchased separately. In peel mode, the printer
separates the liner from the label. The next label is not printed until the completed one is
removed from the printer. Make sure the printer is configured for on-demand mode and
the correct supply type.
The minimum feed length is 1.5 inches for peel mode. We recommend using 0.5-inch gap
supplies in peel mode when backfeed is disabled. Hold the leading edge of peeled labels
when printing on stock longer than six inches. You must use non-perforated supplies for
peel mode.
Follow the steps for loading supplies from the previous section, close the printhead, and
follow these steps.
1. Remove the labels from the first 10 inches of the liner.
2.
Press down on the exit cover tabs to open the exit cover on the front of the printer.
E x i t C o ve r
3. Feed the liner over the peel roller, along the chute, and out through the lower opening
in the exit cover.
P e el Ba r
P l a te n R o ll e r
L ow er O pe n in g
P e el R ol le r
2-6 Operator's Handbook