Avery Dennison Monarch 9906 Operator Handbook - Manual (Page 20)

U s i n g O p t i o n a l I n t e r n a l L i n e r T a k e - U p
Internal liner take-up must be used with peel mode. This feature collects the liner on a
take-up reel located inside the printer’s cover. See “Setting the Feed Mode” for
instructions to set the printer for Internal Liner Take-Up.
Follow the steps for loading supplies for peel mode and then follow these steps.
1.
Press down on the exit cover tabs to open the exit cover on the front of the printer.
2.
Remove the labels from the first 18 inches of the liner.
3.
Position the liner take-up reel so the open notch is facing up.
4.
Position the liner take-up core so the open slot is facing up. Line up the slot in the core
with the notch in the reel. Slide the empty liner take-up core on the liner take-up reel.
O p e n N o t ch
O p e n S l o t
5.
Feed the liner over the peel bar, under the peel roller, under the liner take-up core
and around in a counter-clockwise direction.
6.
Place the end of the liner in the take-up core’s opening.
Note: Fold the edge of the liner to easily insert it in the core’s open slot.
S u p p l y
L i n er
L i n er
L i n er T ak e - up R e el
L i n er T ak e - up C o r e
2-8 Operator's Handbook