Avery Dennison Monarch 9906 Operator Handbook - Manual (Page 65)

S e t t i n g t h e I m a g e E r r o r M o d e
Image errors can occur when there is a problem producing a complete label. Press
ESCAPE
to clear an image error.
Image errors include:
unable to image batch 600 614 portion of field off label
601 problem during imaging 615 invalid PDF417 bar code data
603 missing batch 618 invalid font size
611 invalid font, bar code or density 620 missing font data
612 missing batch data 621 invalid downloaded font
613 reference point off label 622 not enough font memory
Note : Enabling image errors means that if a format does not print as expected then no
error is reported. For example, bar codes require a non-print zone; if a bar code is
placed too close to the edge of the label, no error is reported and the bar code may
not scan properly.
Error 616 (bar code dot shifting failed) is always reported.
To change the image error mode setting, from the Main Menu, select Setup, then
Defaults. Then, follow these steps.
1.
Press  or  until you see No Image Error.
2. Press CHANGE to highlight the image error options. The current setting is shown.
3. Press  or  to scroll through the image error options.
4. When you see the image error mode you need, press SET to save the change. Press
CANCEL
to leave the image error mode unchanged.
CHANGE BACK
DEFAULTS
No Image Error
 Enable ae
SET CANCEL
DEFAULTS
 No Image Error 
CHANGE BACK
Enable
Enable
 No Image Error 
DEFAULTS
5. Press BACK until you return to the Home/Online screen.
Setting Defaults 6-13