Avery Dennison Monarch 9906 Operator Handbook - Manual (Page 27)

7. Position the ribbon so that it unwinds in a clockwise direction. Slide the ribbon onto
the back reel as far as it will go. Carefully unwind a few inches of ribbon from the
bottom of the roll.
T a k e - u
R e e l p
B a c k R ee l
8.
Carefully feed the ribbon under both ribbon rollers and printhead.
9. Align the ribbon and make sure it is straight and centered throughout the path.
R i b b o n
R o l le r
P ri n t h ea d
As s e m b l y
P ri n t h ea d
R e l ea s e
P ri n t h ea d
As s e m b l y
R i b b o n
R o l le r
10. Tape the ribbon to the take-up core. Do not tape the ribbon to the take-up reel.
11.
Rotate the take-up core until the leader is past the printhead.
12. Remove any slack in the ribbon by turning the take-up reel clockwise.
13. Hold the printhead assembly by the printhead tab while pushing the printhead release.
14.
Close the printhead by pressing down on the thumb well until you hear it click into
place.
15.
Close the printer’s cover.
Loading Ribbon 3-3