AMETEK Ls Series - Manual (Page 52)

User Manual Lx / Ls Series
48
3.6.7 System Interface Connectors – MASTER and AUXILIARY
WARNING: The system interface connectors are for use with California Instruments
supplied cables, and only between California Instruments equipment.
A set of two System Interface connectors is located on the rear panel of each 4500Lx/Ls chassis.
The system interface is used to connect the multiple 4500Lx/Ls or 6000Lx/Ls power sources in a
Master/Auxiliary configuration to create a 9000Lx/Ls/2, 12000Lx/Ls/2, 13500Lx/Ls/3 or
18000Lx/Ls/3 AC power source configuration. In this configuration, only the Master power
source has a built-in controller and front panel. The System Interface cable provided in the Lx or
Ls Series ship kit (CI P/N 250778) MUST be used to connect both chassis as shown in Figure
3-3.
Note that no user accessible signals are provided on the System Interface connections and they
should only be used for their intended purpose. To use the System Interface capability, the
output safety cover has to be removed. As such, multi-chassis configurations cannot be used
outside of a cabinet with proper rear screens.
Note that for multi-chassis systems, it is recommended to turn the Master unit ON first and then
the Auxiliary unit(s). To turn the system off, turn OFF the Auxiliary unit(s) first and then the
Master unit.