AMETEK Ls Series - Manual (Page 38)

User Manual Lx / Ls Series
34
Parameter Supplemental Specification
Frequency
Range Standard Lx: 45 – 819 Hz
With –HF option: 45 - 5000 Hz.
Resolution Standard Lx: 0.1 Hz
With –HF option: 1 Hz
Accuracy ± 0.025%
Phase
Phase Resolution Standard: standard specifications apply.
With –HF option: 0.5°
Phase Accuracy Standard: standard specifications apply.
With –HF option: < 2° + 1°/kHz
2.7.6 –EXS Option Ls Series - Supplemental Specifications
The –EXS (External Sync) option allows the output frequency of the AC source to be synchronized to an
external TTL level clock signal.
The following supplemental specifications apply when the Ls is configured with the external sync option. (-
EXS).
Parameter Supplemental Specification
Input
Voltage Input TTL Level square wave.
Impedance 10 KOhm.
Frequency
Range Same as internal clock mode. See configuration limits.
Max Sync Input Slew Rate < 80 Hz / sec.
Changes in sync input frequency occurring faster than this rate will result in
Error 804: External Sync Error. Output relay is opened on Error.
Max Sync Step < 20 Hz.
Sudden changes in sync input frequency greater than 20 Hz will result in
Error 804: External Sync Error. Output relay is opened on Error.
Mode Selection When switching between INT and EXT sync mode, the output of the AC
source will be dropped momentarily.
Restrictions Frequency cannot be programmed in external sync mode.
Frequency transient list system is not available in sync mode.
Transient list dwell times are not correlated to external sync but based on
internal timebase.