AMETEK Ls Series User Manual
Page 14
User Manual
Lx / Ls Series
10
The Ls rear panel connector labeling is compliant with the California Instruments L
Series.
The Lx Series comes standard with both GPIB and RS232C interfaces.
The Ls Series comes standard with an RS232C only, An optional GPIB interface (-GPIB
option) is available.
Note:
Both interfaces use the SCPI command syntax as described in the programming
manual.
The Lx Series provides both three phase and single phase output modes which can be
selected from the front panel or over the bus.
The Ls Series provides either three phase (-3 models) or single phase (-1 models).
Three phase Ls Series sources may optionally be equipped with the
–MODE option
which provides the same phase mode switching as the Lx Series.
1.3 Manual organization and format
All user documentation for California Instruments power sources is provided on CDROM in
electronic format. (Adobe Portable Document Format) The required Adobe PDF viewer is
supplied on the same CDROM. This manual may be printed for personal use if a hardcopy is
desired. To request a hardcopy from California Instruments, contact customer service at
. There will be an additional charge for printed manuals.
This manual contains sections on installation, normal use, maintenance and calibration. The Lx
Series is equipped with both GPIB and RS232C interfaces. The Ls Series is equipped with a
RS232C interface. An optional GPIB interface can be specified at the time of order. Refer to the
Lx / Ls Series Programming manual for information on using the remote control interface and
command syntax. The programming manual (P/N 7004-961) is provided on the same CDROM
as this user manual.
California Instruments may make updated versions of this manual available from time to time in
electronic format through it’s website. To obtain an updated manual revision if available, check
the California Instruments Manual download page a
ou need to register as a
customer to obtain free access to manual and software downloads.