AMETEK Ls Series - Manual (Page 48)

User Manual Lx / Ls Series
44
3.6 Connectors - Rear Panel
A number of connectors are located along the top rear covers. These connectors are in a
recessed area to protect them from shipment damage. A summary of available connectors is
provided in the table below.
Connector
Lx Series
AC Input
(INPUT) Function Connects To
L1 – AC in
L2 – AC in
L3 – AC in
CHASSIS - GND
Primary AC Power Input 208 - 230 VAC nominal (Std)
400 VAC nominal (-400 option)
Note: For 3000Lx/Ls operated from
single-phase AC input, use L2-L3.
AC Output
(OUTPUT) Function Connects To
Ø1
Ø2
Ø3
COM AC output User Load
External Sense Function Table
Sense Ø1, Ø2, Ø3,
COM External Sense Table 3-7
Ls Series
AC Input
(INPUT TB3) Function Connects To
ØA – AC in
ØB – AC in
ØC – AC in
CHASSIS - GND
Primary AC Power Input 208 - 230 VAC nominal (Std)
400 VAC nominal (-400 option)
Note: For 3000Lx/Ls operated from
single-phase AC input, use ØB- ØC.
AC Output
(OUTPUT TB1) Function Connects To
ØA
ØB
ØC
NEUT AC output User Load
External Sense Function Table
Sense ØA HI, ØB
HI, ØC HI, NEUT External Sense Table 3-7
Lx and Ls Series
Remote Control Function Table
RS232 Serial Control Interface Table 3-8
IEEE-488 GPIB Control Interface See IEEE-488 standard for pin out.
System Interface Function Table
Master Connects to Master DB25, MALE
Auxiliary Connects to Auxiliary DB25, FEMALE
Lx Series
Other Function Table
SMA Connectors Discrete Fault Indicator Table 3-4
Remote Inhibit Table 3-4
Trigger Out1
(Function Strobe) Table 3-4
Trigger In1 Table 3-4