BINDER KT 53 - Manual (Page 93)

KT (E6) 09/2013 Page 93/135
14.3 Confirming an active alarm
Fixed value 08.03.2013 15:05:02
Initial view with overtemperature safety controller
alarm.
The buzzer sounds (if not deactivated previously).
Press the “Info” button.
Setpoint Actual value
Temperature [°C]
25.0 29.8
Fan [%]
100.0
User Info Menu
Alarm acknowledgement 08.03.2013 05:05:06
Submenu “Alarms” for alarm acknowledgement.
The active alarm that has been triggered first is
highlighted.
Press the “Reset” button to confirm the alarm and
mute the buzzer.
..\ Home/Alarms
Safety controller overtemperature
Close Reset Home
The initial view is displayed. The alarm is still active, therefore the alarm icon continues to be shown. The
buzzer is off.
If there is another active alarm, you can press the “Info” button again and also confirm the alarm with the
“Reset” button.
The following alarm messages may appear in the “Alarm list”:
Alarm message Signification
Corresponding
alarm icon
Safety controller
overtemperature
Overtemperature safety controller alarm (class 3.1): selected
value of the safety controller exceeded.
Safety controller
overtemperature
Overtemperature safety controller alarm with option class 3.3:
selected value of the safety controller exceeded
Safety controller
undertemperature
Undertemperature safety controller alarm with option class 3.3:
fallen below selected value of the safety controller
Temp. range
Having reached the set-point, the temperature deviates by
more than +/- 2 °C from the entered set-point