BINDER KT 53 - Manual (Page 91)

KT (E6) 09/2013 Page 91/135
Chamber status
Actual chamber status, including operating mode, set-points etc.
Measurement values Measured data
Event list List of status information and errors (see chap. 15)
Time programs All stored time programs
Week programs All stored week programs
Configuration (Service only)
Adjustment Adjustment data
Program parameters (Service only)
System information (Service only)
All All data
If no USB device has been connected, the message “No USB device found” is displayed. It
disappears after inserting the USB stick or the plug of your USB drive into the USB port in the
instrument box.
This symbol on the controller display indicates that data are being transmitted via the USB port.
13.2 Importing data from USB drive
Insert the USB stick or the plug of your USB drive into the USB port in the instrument box.
To configure data import from USB media, go to
Menu > Import/Export > Import from USB drive
Fixed value 08.03.2013 05:05:06
Submenu “Import from USB drive”.
Select the desired data
and press the operating button.
Data is read from the connected media.
..\ Import from USB drive
All time programs
All week programs
Configuration
Close Home
All time programs
All stored time programs
All week programs All stored week programs
Configuration (Service only)
Select the desired data type and press the operating button. Data will be imported from the connected
media.
If no USB device has been connected, the message “No USB device found” is displayed. It
disappears after inserting the USB stick or the plug of your USB drive into the USB port in the
instrument box.
This symbol on the controller display indicates that data are being transmitted via the USB port.