BINDER KT 53 - Manual (Page 72)

KT (E6) 09/2013 Page 72/135
Entering the set-point values for another parameter (fan speed)
The number of program lines (program sections) equal to the number in the temperature program is
displayed. The settings of the shift points (day, time, activity) are taken over from the temperature
program; they are no editable in this view. You can enter the fan speed set-points.
If you want to insert further sections or perform any other programming, first change back to
the temperature program through Menu > Select parameter > Temperature controller .
Fixed value 08.03.2013 05:05:06
Week program editor (example).
..\ Fan speed [%]
No. Value Day H:M:S Activity
1 100.00 Monday 10:00:00 Active
1 100.00 Monday 12:00:00 Active
1 100.00 Monday 00:00:00 Inactive
Menu
Entering the fan speed setpoint
Fixed value 08.03.2013 05:05:06
Week program editor.
Select a value under “Value”
and press the operating button.
..\ Fan speed [%]
No. Value Day H:M:S Activity
1 100.00 Monday 00:00:00 Inactive
Fixed value 08.03.2013 05:05:06
Entry menu “Fan speed setpoint”.
A fan speed value is shown. Enter the desired value
with the operating button.
Setting range: 40 % up to 100 %
Press the “Ok” button to confirm.
..\ Fan speed setpoint
1 00 [%]
1
Pos1 End Ok 0 2 3 4 5 6 7 8 9 ,
Close Ok
When entering a value outside the setting range, the message “invalid value” appears. Press the
operating button to confirm with “Ok” and repeat the entry with a correct value.