Altera Stratix III Development Board - Manual (Page 12)

2–4 Chapter 2: Board Components
Featured FPGA (U22)
Stratix III 3SL150 Development Board May 2013 Altera Corporation
Reference Manual
Featured FPGA (U22)
The Stratix III Development Kit features the EP3SL150F1152C2 device (U22) in a
1152-pin BGA package.
f
For more information about Stratix III devices, refer to the Stratix III Device Handbook .
Table 2–2 lists the main Stratix III EP3SL150 device features.
Table 2–3 lists the Stratix III device component reference and manufacturing
information.
Table 2–4 lists the Stratix III device EP3SL150F1152 pin count.
U15 QDRII
Burst-of-four, 2M × 18, 400-MHz QDRII memory interface in an FBGA
package.
J19 DDR2 SDRAM DIMM Connector for 1 GByte × 72 DDR2 SDRAM DIMM.
Components and Interfaces
U11 USB device
USB device that provides JTAG programming of on-board devices,
including the Stratix III device and flash memory device.
J14 Ethernet cable jack
The RJ-45 jack is for Ethernet cable connection. The connector is fed
by a 10/100/1000 base T PHY device with an RGMII interface to the
Stratix III device.
J8 and J18 HSMC Port A and Port B HSMC connectors to allow for expansion via the addition of HSMCs.
Power Supply
J21 DC power jack 14–20 V DC power source.
SW4 Input Switches the board’s power on and off.
Table 2–1. Stratix III Development Board (Part 3 of 3)
Board Reference Type Description
Table 2–2. Stratix III EP3SL150 Device Features
ALMs LEs
M9K
Blocks
M144K
Blocks
MLAB
Blocks
Total
Embedded
RAM Kbits
MLAB
Kbits
Total
Memory
Kbits
18 × 18 Bit
Multipliers
PLLs
57 142.5 355 16 2,850 5,499 1,781 7,280 384 8
Table 2–3. Stratix III Device Component Reference and Manufacturing Information
Board Reference Description Manufacturer
Manufacturing
Part Number
Manufacturer
Website
U22 High-speed, low-power FPGA Altera Corporation EP3SL150F1152 www.altera.com
Table 2–4. Stratix III Device Pin Count (Part 1 of 2)
Function I/O Type I/O Count Special Pins
Oscillators and SMAs 1.8-V CMOS 4 Three clock inputs, one output
DDR2 DIMM 1.8-V SSTL 136 18 data strobe signal (DQS) pins
DDR2 devices 1.8-V SSTL 74 Four DQS pins