Altera Arria V GX Starter Board - Manual (Page 44)

2–36 Chapter 2: Board Components
Components and Interfaces
Arria V GX Starter Board November 2013 Altera Corporation
Reference Manual
Table 2–35 lists the HSMC connector component reference and manufacturing
information.
SDI Video Output/Input
The SDI video port consists of a LMH0303 cable driver and a LMH0384 cable
equalizer. The PHY devices from National Semiconductor interface to single-ended
75-
Ω SMB connectors.
The cable driver supports operation at 270 Mbit standard definition (SD), 1.5 Gbit
high definition (HD), and 2.97 Gbit dual-link HD modes. Control signals are allowed
for SD and HD modes selections, as well as device enable. The device can be clocked
by the 148.5 MHz voltage-controlled crystal oscillator (VCXO) and matched to
incoming signals within 50 ppm using the UP and DN voltage control lines to the
VCXO.
Table 2–36 lists the supported output standards for the SD and HD input.
f
For more information about the application circuit of the cable driver, refer to the
cable driver data sheet in
www.national.com .
Table 2–37 summarizes the SDI video output interface pin assignments, signal names,
and functions.
The cable equalizer supports operation at 270 Mbit SD, 1.5 Gbit HD, and 2.97 Gbit
dual-link HD modes. Control signals are allowed for bypassing or disabling the
device, as well as a carrier detect or auto-mute signal interface.
Table 2–35. HSMC Connector Component Reference and Manufacturing Information
Board Reference Description Manufacturer
Manufacturing
Part Number
Manufacturer
Website
J13
HSMC, custom version of QSH-DP
family high-speed socket.
Samtec ASP-122953-01 www.samtec.com
Table 2–36. Supported Output Standards for SD and HD Input
SD_HD Input Supported Output Standards Rise TIme
0 SMPTE 424M, SMPTE 292M Faster
1 SMPTE 259M Slower
Table 2–37. SDI Video Output Interface Pin Assignments, Schematic Signal Names, and Functions
Board
Reference (U18)
Schematic
Signal Name
Arria V GX
Pin Number
I/O Standard Description
1 SDI_TX_P L32 1.5-V PCML SDI video output P
2 SDI_TX_N L31 1.5-V PCML SDI video output N
6 SDI_TX_EN AC24 2.5-V Device enable
7 SDI_SDA AJ28 2.5-V Cable driver I 2 C bus
8 SDI_SCL AH28 2.5-V Cable driver I 2 C bus
10 SDI_TX_SD_HDN AC25 2.5-V High-definition select
13 SDI_FAULT AJ29 2.5-V Data transmission fault