Altera Arria V GX Starter Board - Manual (Page 25)

Chapter 2: Board Components 2–17
Setup Elements
November 2013 Altera Corporation Arria V GX Starter Board
Reference Manual
Table 2–9 lists the board-specific LEDs component references and manufacturing
information.
Setup Elements
The starter board includes several different kinds of setup elements. This section
describes the following setup elements:
■ Board settings DIP switch
■ JTAG settings DIP switch
■ PCI Express control DIP switch
■ CPU reset push button
■ MAX V reset push button
■ Image load push button
■ Image select push button
Table 2–10 lists the switch and push button component references and manufacturing
information.
D1 SDI_RX_CDn 3.3-V
Green LED. Illuminates to indicate that input signal is detected at the
SDI RX port. Driven by the SDI cable equalizer.
D15 HSMA_PRSNTn 3.3-V
Green LED. Illuminates when HSMC port A has a board or cable
plugged-in such that pin 160 becomes grounded. Driven by the
add-in card.
Table 2–8. Board-Specific LEDs (Part 2 of 2)
Board
Reference
Schematic Signal
Name
I/O
Standard
Description
Table 2–9. Board-Specific LEDs Component References and Manufacturing Information
Board Reference Description Manufacturer Manufacturer Part Number Manufacturer Website
D1 – D9,
D11 – D15,
D24 – D26, D33
Green LEDs Lumex Inc. SML-LXT0805GW-TR www.lumex.com
D10 Red LED Lumex Inc. SML-LXT0805IW-TR www.lumex.com
D30 Blue LED Lumex Inc. SML-LX0805USBC-TR www.lumex.com
Table 2–10. Switch and Push Button Component References and Manufacturing Information
Board
Reference
Description Manufacturer
Manufacturer
Part Number
Manufacturer
Website
SW1, SW2, SW4 Four-position DIP switch
C&K Components/ ITT
Industries
TDA04H0SB1 www.ittcannon.com
S1–S4 Push button Panasonic EVQPAC07K www.panasonic.com