Altera Stratix V GX FPGA Development Board - Manual (Page 68)

2–60 Chapter 2: Board Components
Temperature Sense
Stratix V GX FPGA Development Board October 2014 Altera Corporation
Reference Manual
Table 2–60 lists the power measurement ADC component references and
manufacturing information.
Temperature Sense
Temperature monitoring for the Stratix V GX FPGA die is achieved with a MAX1619
temperature sense device. The MAX1619 device connects to the MAX V CPLD
EPM2210 System Controller and the Stratix V GX FPGA device by a 2-wire SMB
interface. The MAX1619 device is located at address 0x1. This bus is also routed to a
single voltage and power monitor chip for the 12-V power rail at address 0x2.
The OVERTEMPn and TSENSE_ALERTn signals are driven by the MAX1619 temperature
sense device based on a programmable threshold temperature. The OVERTEMPn signal
is driven to the MAX V System Controller, which controls the OVERTEMPn signal. The
MAX V System Controller can control fan speed based on a register setting and can
also override the MAX1619 device. For more information on this control, refer to the
MAX V System Controller source code found in the development board installation
directory \stratixV_GX_fpga\examples\max5.
f
For more information on the development board installation directory, refer to the
Stratix V FPGA Development Kit User Guide .
The remote sense routes to the FPGA's diode pins to measure the voltage drop. For
very accurate temperature readings, the I/O adjacent to the FPGA diode sense pins
must be halted.
5 S5_VCC_1p5 1.5
VCCD_FPLL PLL digital power
VCCH_GXB XCVR block level transmit buffers
VCCPT Programmable power tech auxiliary
6 S5_VCCIO_2.5V 2.5
VCCIO_3A I/O supply bank 3A
VCCIO_3B I/O supply bank 3B
VCCIO_4B I/O supply bank 4B (HSMC Port A)
VCCIO_7B I/O supply bank 7B (HSMC Port A)
7 S5_VCCIO_1.5V 1.5
VCCIO_8A I/O supply bank 8A (DDR3 RZQ)
VCCIO_8B I/O supply bank 8B (DDR3)
VCCIO_8C I/O supply bank 8C (DDR3)
VCCIO_8D I/O supply bank 8D (DDR3)
8 S5_VCCA_GXB 3.3 VCCA_GXB XCVR TX driver, RX receiver, CDR
Table 2–59. Power Rail Measurements Based on the GUI Selection (Part 2 of 2)
Number Schematic Signal Name Voltage (V) Device Pin Description
Table 2–60. Power Measurement ADC Component References and Manufacturing Information
Board Reference Description Manufacturer
Manufacturing
Part Number
Manufacturer
Website
U52 8-channel differential 24-bit ADC Linear Technology LTC2418CGN#PBF www.linear.com
U1 1-channel differential 14-bit ADC Linear Technology LTC2990IMS#PBF www.linear.com