Vhdl library_use declaration, Ports, Vhdl library_use declaration -3 – Altera Integer Arithmetic IP User Manual
Page 153: Ports -3
The VHDL component declaration is located in the VHDL Design File (.vhd)
altera_mf_components.vhd in the
\libraries\vhdl\altera_mf
directory.
component parallel_add
generic (
width : natural := 4;
size : natural := 2;
widthr : natural := 4;
shift : natural := 0;
msw_subtract : string := "NO";
representation : string := "UNSIGNED";
pipeline : natural := 0;
result_alignment : string := "LSB";
lpm_hint: string := "UNUSED";
lpm_type : string := "parallel_add");
port (
data:in altera_mf_logic_2D(size - 1 downto 0,width- 1 downto 0);
clock : in std_logic := '1';
aclr : in std_logic := '0';
clken : in std_logic := '1';
result : out std_logic_vector(widthr - 1 downto 0));
end component;
VHDL LIBRARY_USE Declaration
The VHDL LIBRARY-USE declaration is not required if you use the VHDL Component Declaration.
LIBRARY altera_mf;
USE altera_mf.altera_mf_components.all;
Ports
The following tables list the input and output ports of the PARALLEL_ADD megafunction.
Table 12-2: PARALLEL_ADD Megafunction Input Ports
Port Name
Required
Description
data[]
Yes
Data input to the parallel adder. Input port
[SIZE - 1 DOWNTO 0, WIDTH-
1 DOWNTO 0]
wide.
clock
No
Clock input to the parallel adder. This port is required if the
PIPELINE
parameter has a value of greater than
0
.
clken
No
Clock enable to the parallel adder. If omitted, the default value is
1
.
aclr
No
Active high asynchronous clear input to the parallel adder.
Table 12-3: PARALLEL_ADD Megafunction Output Ports
Port Name
Required
Description
result[]
Yes
Adder output port. The size of the output port depends on the
WIDTHR
parameter value.
UG-01063
2014.12.19
VHDL LIBRARY_USE Declaration
12-3
PARALLEL_ADD (Parallel Adder)
Altera Corporation